How do I set the ProSight into boot mode?

Submit a request
Avatar
Idan Pearl

This article will explain how to set the ProSight system in boot mode.

What is boot mode?

Boot mode is a special software mode, where some of the software has been erased in order to recover the system from some failures.

In which problems should this mode help?

In some cases where the upgrade fails, this mode will help. When in boot mode, most of the system abilities will be shut down (since some part of the software is erased), and will only regain normal behavior after upgrading.

How to get the Air unit into boot mode?

In order to do that, you will need to use a small pin.

  • Power off the unit.
  • Using a small pin, press the small button beside the LEDs (seen below):

  • Power on the unit.
  • Release the button.
  • Connect the USB cable between the unit and the computer.
  • Update the unit.

How to get the Ground unit into boot mode?

  • Power off the unit.
  • Press the middle button (SEL).
  • Power on the unit.
  • Release the button.
  • Connect the USB cable between the unit and the computer.
  • Update the unit.

 

 

Was this article helpful?
1 out of 2 found this helpful

Comments