How do I change my OSD details?

Submit a request
Avatar
Shahar Keren

Setting OSD Overlays

This section reviews the overlay displayed on top of the video image. The overlay is selected for the following communication modes:

  • My drone – when connected to the paired drone
  • Other drone – when connected to other drones as a viewer

The OSD menu also allows you to select the color of the telemetry information displayed on the OSD. For details, see Setting Telemetry Color

 Selecting My Drone Overlay

To set the viewing mode for the paired drone:

  1. Select Main Menu > Setup > OSD > My drone.


  2. Use the SEL button to toggle between the following overlays:

Selecting Viewer Overlay

To set the viewing mode when connected as a viewer:

  1. Select Main Menu > Setup > OSD > Other drones.

  2. Use the SEL button to toggle between the following overlays:

Detailed Overlay

The Detailed overlay displays the following information on top of the live video:

  • Transmitter name (1)
  • Signal level (2) – there are three levels:
    •  - best signal
    • - signal is weakening
    • - it is recommended to bring the drone closer to the receiver
  • Frequency mode (3)
  • Battery voltage (4) – blinks and turns red if the measured voltage is below the predefined threshold (see Setting Power Alert Threshold)
  • Flight duration (5) – counts the flight time in seconds. Count start time depends on the following:
    • When the HD transmitter telemetry port is connected to the flight controller, time starts counting when the drone is armed.
    • When the telemetry port is not connected, time starts counting once the drone is powered on.

Race Overlay

The Race overlay displays the following information on top of the live video:

  • Flight duration (1)
  • Battery voltage (2)

Viewer Overlay

The Viewer overlay displays the following information on top of the live
video:

  • Transmitter name (1)
  • ProSight logo (2)

 

No Overlay

This selection displays no overlay on top of the live video.

Setting Telemetry Color

To set the color of the telemetry information displayed on the OSD:

  1. Select Main Menu > Setup > OSD > Telemetry Color.


  2. Select one of the following colors:
    • White
    • Black
    • Green

Tip: Select Back to return to the Main Menu.

Was this article helpful?
0 out of 0 found this helpful

Comments