Installing the HD transmitter

Submit a request
Avatar
Shahar Keren

Connecting Components to Drone

Preparing the Mounting Plate

Mark mounting holes for the following components:

  • Camera (1) – 3 holes 
  • Transmitter (3) – 4 holes
  • Antenna (4) – 4 holes

Note: Consider the Camera Cable length (2 3/4inch / 7cm) between the camera and the transmitter (2).

 

 

Attaching the HD Transmitter

  1. Connect the 4 mounting bases (1) to the mounting plate using 4 screws (2).
  2. Place the HD transmitter (4) on the 4 mounting bases (3). 
  3. Connect the HD transmitter to the mounting bases using 4 screws (1).
     

Note: Notice the transmitter orientation. The video connector (2) should face the camera and the antenna sockets must remain exposed.

Was this article helpful?
0 out of 1 found this helpful

Comments