Setting Up the CONNEX mini Ground Unit

Submit a request
Avatar
Support

This section describes how to set up the CONNEX mini Ground Unit (receiver).

We highly recommend that you use the provided AMIMON accessories and cables. If alternate products are used, make sure that they are of the highest quality.

To set up the CONNEX mini Ground Unit:

  1. Refer to the Placement Guidelines for a description of mandatory requirements and best practices for optimal placement of the Ground Unit and its antennas.
  2. Screw on the three provided antennas to the three Ground Unit antenna connectors, as shown below:

    Connecting the Ground Unit Antennas

  3. Enable display of the received video by connecting the provided standard HDMI cable from the Ground Unit HDMI port to the monitor’s HDMI port.


    Standard HDMI Cable




  4. Connect the provided power cable to the power port on the Ground Unit labeled 8-26-VDC, and connect the other end to a power source. 

    Verify that both LEDs on the Ground Unit light up, as described in the tables below.

LED Behavior

The CONNEX mini features two LED indicators: a Video LED and a Network LED. In normal operating conditions, both LEDs show a constant white color. No power (or low power) is indicated by the LEDs turning off.

When the indicators are blinking quickly (both LEDs), a system error has been detected. In this case, use the CONNEX Management application to update the software, or contact CONNEX support.

The behaviors of each individual LED are described in the tables below.

 Ground Unit – Video LED

Solid

The video signal from the camera is locked (i.e., the signal is being received from the Air Unit).

Blinks Slowly

The video signal from the camera is not locked.

Blinks Quickly

The camera is transmitting a video resolution that is not supported.

 Ground Unit – Network LED

Solid

A link has been established to the Ground Unit. 

Blinks Quickly

Registration is in progress, or the Ground Unit has gone out of range.

Blinks Slowly

The Air Unit is establishing a link with the Ground Unit.

Was this article helpful?
0 out of 0 found this helpful

Comments