Why is the Futaba T14SG radio controller not controlling the Gimbal on my drone?Submit a request
The Futaba T14SG radio controller should be able to control the Gimbal. Please try the suggestions below:
- Ensure the RC (T14SG or other S.BUS RC) mode is set to 16CH so the trainer's port is configured to work in S.BUS mode (rather than PPM mode).
- Configure the RC channels to control the Gimbal motor movements.
- CONNEX supports up to 16 channels, with packet transfers every 6.3mSec (FASSTest 12CH) or 15mSec (FASSTest 18CH or T-FHSS Mode). Configure this mode using the CONNEX Application tool through your computer (connect via USB to the Air Unit).