Installing the HD transmitter

Submit a request
  1. CONNEX Support
  2. ProSight
  3. Installing the On-Drone Components
Avatar
Permanently deleted user

Connecting Components to Drone

Preparing the Mounting Plate

Mark mounting holes for the following components:

  • Camera (1) – 3 holes

  • Transmitter (3) – 4 holes

  • Antenna (4) – 4 holes

Note

Note: Consider the Camera Cable length (2 3/4inch / 7cm) between the camera and the transmitter (2).

Attaching the HD Transmitter

  1. Connect the 4 mounting bases (1) to the mounting plate using 4 screws (2).

  2. Place the HD transmitter (4) on the 4 mounting bases (3).

  3. Connect the HD transmitter to the mounting bases using 4 screws (1).

Note

Note: Notice the transmitter orientation. The video connector (2) should face the camera and the antenna sockets must remain exposed.

Was this article helpful?
0 out of 1 found this helpful

Comments