Pairing the HD Transmitter and Receiver

Submit a request
Avatar
Shahar Keren

This section describes the procedure for pairing an HD receiver with an HD transmitter. CONNEX ProSight units are already paired when delivered. The pairing process is required when connecting to an unpaired HD transmitter for the first time.

  1. Verify that both HD transmitter and HD receiver are powered on.

  2. Connect the USB to Micro USB cable and the OTG cable between the HD transmitter Micro USB port (1) and the HD receiver Micro USB port (2).

  3. Verify that the Network LED (1) on the HD receiver blinks for a few seconds and is lit constantly when pairing is completed. This process takes a few seconds.

After successful pairing, the following message appears on the screen: Registration Succeeded, Please Disconnect Cable.

Was this article helpful?
0 out of 0 found this helpful

Comments