How to install and set CONNEX to control the DJI Ronin Gimbal (video)Submit a request
NOTE: This setting procedure below is correct for both the Ronin and Ronin-M gimbals.
This video shows how to connect CONNEX Air unit to the DJI Ronin Gimbal, using a Futaba T14SG RC.
NOTE: The installation procedure below is correct for both the Ronin and Ronin-M gimbals.
Attach the CONNEX Air Unit to the bottom of the Ronin control unit using Velcro and connect the antennas using strips facing down as seen in the image below:
Power the CONNEX Air Unit using a D-tap to 4 pin JST connector. Modify the power cable; refer to the these articles for instructions here and here. The example image below shows a CONNEX Air Unit powered using a D-tap to DC-Jack and a DC-Jack to 4 pin JST.
Connect one end of the S.BUS cable to the S.BUS port on the CONNEX Air Unit and connect the other end to the D.BUS port of the Ronin-M.