What is the control channel rate?

Submit a request
  1. CONNEX Support
  2. CONNEX
  3. Operational FAQ
Avatar
Permanently deleted user

CONNEX allows transfer of control signals to the camera's gimbal using S.BUS or PPM protocol. PPM support is available only from SW version 2.x.x and up.

The uplink control channel supports up to 16 PWM channels, with packet transfer every 6.3mSec (FASSTest 12CH) or 15mSec (FASSTest 18CH or T-FHSS Mode).

Was this article helpful?
0 out of 0 found this helpful

Comments