Connecting the Telemetry/MAVLink Port (CONNEX)

Submit a request
Permanently deleted user

The following procedure describes how to connect the Air Unit Telemetry/MAVLink port to the drone's flight controller so the Ground Unit monitor can display information received from the drone's flight controller overlaid on the video (such as flight mode, number of connected GPS satellites, speed, height, orientation and more).

To connect the Telemetry port:

  • Connect the Air Unit Telemetry port to the drone using the provided Air Unit Telemetry cable.

    The right side of this cable goes into the Air Unit Telemetry port.

    The left side of this cable goes into the Telemetry port of the flight controller on the drone.

Figure 15. Connecting the Air Unit Telemetry Cable - Box 6

Connecting the Air Unit Telemetry Cable - Box 6


Note: Not all flight controllers are supported. For a list of tested models, refer to Supported flight controllers for telemetry.

Was this article helpful?
0 out of 1 found this helpful