Why is the Futaba T14SG radio controller not controlling the Gimbal on my drone?

Submit a request
Avatar
Shahar Keren

The Futaba T14SG radio controller should be able to control the Gimbal. Please try the suggestions below:

  1. Ensure the RC (T14SG or other S.BUS RC) mode is set to 16CH so the trainer's port is configured to work in S.BUS mode (rather than PPM mode).

  2. Configure the RC channels to control the Gimbal motor movements.

  3. CONNEX supports up to 16 channels, with packet transfers every 6.3mSec (FASSTest 12CH) or 15mSec (FASSTest 18CH or T-FHSS Mode). Configure this mode using the CONNEX Application tool through your computer (connect via USB to the Air Unit).

Was this article helpful?
0 out of 0 found this helpful

Comments