Can I control the Camera's Gimbal through CONNEX?

Submit a request
Permanently deleted user

CONNEX supports the control of the camera's Gimbal, where the Gimbal has either S.BUS or D.BUS control interfaces.

  • Use the S.BUS cable provided with the CONNEX Air Unit to connect the Air unit S.BUS port to the S.BUS port on the camera's Gimbal.

  • Use the S.BUS or PPM cable provided with the CONNEX Ground Unit to connect the RC unit "Trainer Port" output with the CONNEX Ground unit S.BUS input port.

For list of supported RC units and Gimbals see Supported Remote Controls, Gimbals and Telemetry Flight Controllers

Was this article helpful?
0 out of 0 found this helpful