Installing the CONNEX Air Unit Mounting Kit on the Z15 for GH4 Gimbal (Video at the end)
Submit a request
This article explains how to install the CONNEX Air Unit Mounting Kit on the Z15 for GH4 Gimbal.
The CONNEX Air Unit Mounting Kit for the DJI Z15 Zenmuse Gimbal enables two key requirements:
Zero latency HD video wireless transmission from the drone camera
Full 360 degrees Gimbal rotation
Note
NOTE: This Mounting kit does not allow a 360 degrees control over the Gimbal, nor does it allow the option of a 360 degrees telemetry cable movement.
This article contains the following sections:
Installation Phases
The following procedure explains how to perform the mounting process.
-
Connect the two antennas mounted to the main frame using 2 M5x10 black plastic screws.
Note
Note: Place a full 90 degrees rotation between the two antennas' orientation.
-
Connect the CONNEX Air Unit to the main frame using 2 M2.5x5 flat head screws.
Connect the cross plate to the main Aluminum made frame using 2 M2.5x5 pan head screws.
-
Use the provided power cable to power the CONNEX Air Unit directly from the Z15 Gimbal.
Connect one end of the power cable to the Can-bus connector found on the top of the roll motor.
-
Place the omega holder over the rear axle of the Z15 Gimbal, grabbing the Z15 pole using 4 M2x6 screws.
-
Connect the other end to the CONNEX power input.
-
The final result should look as below:
Power Cable Pin Diagram
The Pins for this configuration should be as follows:
The two center pins are live (hot)
-
The top and bottom pins are GND
Video - Installing the CONNEX Air Unit mount for the Z15
The video below describes how to install the CONNEX Air Unit mount for the Z15 installation. Please note that this connection allows you to use the 360 rotation feature of the gimbal when implemented with CONNEX.